rb25det greddy intake manifold install kit

I really need some help with my greddy intake manifold.Preferably if you have just installed one.

There is a line that goes around the back end of the motor from the turbo and it ends as it is coming around the back left corner.

What line is this What do I do with it 2 - Ok, so there are like 4 nipples on the bottom side of the manifold, towards the back.

What exactly goes to all of these nipples If possible, can somebody just go look at theirs and write down exactly where they have each one going to Thanks I think one goes to the FPR, one goes to the waste gate, and Im not sure where the other goes, and I think the bigger one goes to the cam breather hose.

As for the vacuum ports, the larger nipple if for the PCV valve-I used the others for the FPR, BOV and my boost gauge(I teed my WG vacuum source from the FPR).

Here is a great write up that I used to get through the install, it has all the info you will need for it: XLR8S14 wrote: ok, so Ive been trying to get simple information on another 240sx forum, but so far no luck.

Whatever you have left can be used for boost gauge, fpr, bov and wastegate although I prefer to run my wastegates signal from the intercooler piping so it never sees vacuum.

Cap off whatever you dont use and try not to tee anything if you dont have too.

This line needs to be connected to the big fitting on the manifold so your booster can function properly or else your brakes would feel stiff like when your car is off.

You need to start doing a lot of reading buddy, from what I can tell you are not too experienced with cars and the RB can be a big kick in the sack for a newbie.

Good luck and use the search function like its your new best friend.

If all else fails post up and well see if we can get you through this lol.

Rb25Det Greddy Intake Manifold Install Kit